Type tray - allows only continuous walls
style of the fingers
minimal space at the start and end in multiple of normal spaces
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
width of the fingers (multiples of thickness)
extra space to allow finger move in and out (multiples of thickness)
space between fingers (multiples of thickness)
width of finger holes (multiples of thickness)
inside angle of the feet
height of the feet (multiples of thickness)
distance from finger holes to bottom edge (multiples of thickness)
width of the feet (multiples of thickness)
"spring", "stud" or "none"
horizontal width of the hook
vertical spacing of slots middle to middle (in mm)
space surrounding connectors (multiples of thickness)
sections left to right in mm 🛈
sections back to front in mm 🛈
inner height in mm (unless outside selected)
inner height of inner walls in mm (unless outside selected)(leave to zero for same as outer walls)
treat sizes as outside measurements 🛈
edge type for bottom edge
additional height of the back wall
radius for strengthening walls with the hooks
thickness of the material (in mm) 🛈
format of resulting file 🛈
width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈
print surrounding boxes for some structures 🛈
label the parts (where available)
print reference rectangle with given length (in mm)(zero to disable) 🛈
style for inner corners 🛈
burn correction (in mm)(bigger values for tighter fit) 🛈
Generate Save to URL
